Interested to Buy Any Domain ? << Click Here >> for more details...
what happens if power factor is maintained at 0.9?give me
the answer in technicall way rather than telling the
penality n all
- 5 Answers
- 10875 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / badri narayan satpathy
If the power factor is .9 then we get a power loss.
Because power = volatse*current*cos phi(active power)
there for we also paid tha bill including the losses and
the losses is an usefullpower.power factor depend on the
type load like
inductive
capacitive
resitive
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to size Air Circuit breaker (ACB)? What is the most important factors?
Motor,transformers,capacitor tubelight etc....
what happens if dc supply is given and the remedies for it.
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
how does high earth to neutral voltage affects electronic circuit?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
Where can i get practical knowledge of solar system?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
Define cut-off rate?
how works inductive &capacitive sensors?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is “pu” in electrical engineering?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
