Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jagjeet singh solanki
100 MVA TRANSFORMER OF AREVA AND ABB AND EMCO COOLED BY ONAN AT 80 MVA AND ABOVE THIS ONAF METHOD.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
What does the term “voltage regulation” means?
Circuit diagram of tube light without starter using electrical choke
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
how to test and calculat the head and discharge in borewell compressor
Define relative stability.
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
can the measured percentage error during calibration of single phase energy meter be negative?
List some examples of renewable energy?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What happens when two positively charged material is placed together?
Use of switch mode power converter in real-time basis?
what are the application of over current relay?
what are the ''pitting rings''and how cn they be controlled in a series generator
