what is the importance of fault level in power system and how is it decided
- 2 Answers
- 9786 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishal ingle
Fault level is useful to decide Circuit Breaker rating in
power system . Major factors affecting the fault level are
1. Number of Lines connected to Bus bar & their lengths
2. distance of the s/s from source i.e generator. Capacity
of power station. path of power from the power plant.
3. soil strata. etc
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is core CT & it's function?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
explain with diagram how to protect transformers and substations from over current with help of CT's?
how did the testing of protection relays done through current injection
use of PIR in ehv breaker
what is plunger and what's the use of it in motor alignment?
What is meant by harmonic distortion?
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
What is the differentional relay...what is the work of this in power Tx. how it is works..
what is physical distance of isolator to VCB in 33/11kv sub stations
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
