why t/f are rated in kva. is it conserned with p.f.
- 3 Answers
- 4369 Views
- I also Faced
- E-Mail Answers
Answer Posted / jameel
the design of windings of transformer depend on the voltage
and current that is meaning kva .
morover the transformer hasnot mechanical output load such
as motor to say the power in kw.
only we calclate iron losses and copper losses in kw.
also the power factor in windings changes according to the
loads which connection in the secondary windings
usually trasformer and generator rated power in kva but the
motor in kw which is the useful power or active power.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
what is vtg limit of earth and neutral at transformer side?
what is meant by twilight switches 7 where its applicable ?
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
How to do stting of vl250 siemens MCCB
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
what is the ATS .And how it works.
what are the Alarm, Trip & Safety equipment (Issues) present in Power Transformers pls Mail it to ashokbabunhce@gmail.com
How does the slip regulator works as a startor
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
What is the phase relationship between the primary and secondary voltages of a transformer?
