Interested to Buy Any Domain ? << Click Here >> for more details...
Why only three phase power generation are load are used
- 2 Answers
- 6490 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / aniket
three phase supply is used
1.to for higher load
2. more than 3 phase ie 6 phase make alternator complex and
losses in alternator increses,more copper is required.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
how to calculate transformer load?
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
why the active power flow of some line is increased when the active power of out is cut ?
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
what is tri state logic gate
difference between main metering kiosk and check metering kiosk
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
What is ramp signal?
How to set a Zone 1 distance relay for distribution feeder?
How to Preparation of online test
How much no load current of synchronous motor
what is PID control in VFD drives?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
tell me about eletrical contractor
