Answer Posted / susanta kumar behera
we know that the form factor is the ratio r m s value
to average value which result is 1.1 so ht voltage
rating is multiply of 11.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
briefly explain the main blocks found in a microprocessor based system
what is mean by restructuring power system?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
what percent do you derate your copper wire when you change from copper buss to copper wire
Write masons gain formula.
send me all basic electrical question and answers
how many joints are allowed in underground HT cable of 1 KM
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
how can i find cable size from current rating?
What do you mean by a phase angel of instrument transformer?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What is the ratio of Booster transformer?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
boiler is running in rankine cycle and deisel generator is....?
