Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use negetive (-)voltage in vibration system
- 4 Answers
- 12269 Views
- I also Faced
- E-Mail Answers
Answer Posted / md. rizwan
Because we measure the negative voltage in vibration system.
| Is This Answer Correct ? | 3 Yes | 19 No |
Post New Answer View All Answers
what is the reason while warning lamp is on while the engine is cranking?
draw the block diagram of a level transmitter ?
What is difference between Ionization heat and bimetallic heat
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
How u measure the massflow in orifice flow measurement techniques
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
how to work static pressure sensore how to work dpt
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Explain PID controller tuning & any one method used for it.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
