Interested to Buy Any Domain ? << Click Here >> for more details...
How much Fault current can be contributed by a motor?
- 4 Answers
- 8181 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishal ingle
THE QUESTION IS LITTLE BIT VAGUE. MOTOR ACTUALLY IS A LOAD
THEN HOW IT CAN SUPPLY THE FAULT CURRENT? I AM ALSO IN A
STATE OF CONFUSION.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the heat load for a electrical room
why HT armoured cable does not glanding
What is the general system requirement of alternator?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
how slip power recovery system work
Why efficiency in thermal power plant is low?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
what are the analog quality input for protection function?what are minimum reqiments?
What is effect of over voltage and under voltage on ACB
Is vtg is controlled by the resistor? if else how much?
tell me about eletrical contractor
What is s-domain and its significance?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
PAC and simple Ac different
