is manifold required for an integral orifice meter?
- 2 Answers
- 4211 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
yes, u will need a manifold on integral type orifice meter..
so u can use it for impulse piping or u can mount ur flow
transmitter directly online.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
where proximity sensor installed on tank in loading arm application
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
Explain plc level and its type?
how to calibrate 0- 150 psi presure gauge by dead weght tester
what is the working principal of pribe
Where is wet leg is used?
What is standard procedure of manual mapping in Radar type level transmitter?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
