Answer Posted / ajeet
Its like a node in a electrical circuit,which is used for the connection to the other transmission line.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why and how current drawn by battery charger depends upon the altitude where it is located?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
Could you measure voltage in series?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
Phase control and integral control are used for?
how invertor convert the dc into ac give brif detail
Can a generator runs after getting 1st stator earth fault.
A d.c. Shunt motor is found suitable to drive fans because they require?
Do closed loops systems require manual input?
Iwould like to know barc interview questions
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
define as synchronous generator
