Interested to Buy Any Domain ? << Click Here >> for more details...
how can we find out the ratio of cement and sand in plastering
- 2 Answers
- 7268 Views
- I also Faced
- E-Mail Answers
Answer Posted / himansu sekhar pradhan
Take some motar sample of plastering then poured into a
measuring jar. Then add sufficient water and sake
vigorously then kept cylinder on a non vrabating place for
minimum two hours. Then calculate the ratio of volume of
fine cement layer at top and sand layer at bottom.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is conventional shuttering rate per square feet of built up area? what is Mivan shuttering rate per square feet of built up area? what is coupler shuttering rate per square feet of built up area?
why is M30 grade Concrete use for Foothing & Column M50
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
What is Time period of a building and its relation with frequency ?
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
Is it necessary to apply tack coat over the primecoat. IF not what happens.answers other than 1.to superimpose the next layer(2) to adhere the layers so as to form homogenity.
Is it possible to make a feature using an overdefined sketch?
how to check and keep control on the wastage of material at site
What is the zero value in quantity surveying
What is the coeffiencent Friction Angle between Steel and Ashphalt?
how calculate the bearing from two coordinates?
how to identify np3 pipe and np4 pipe
what is the hanekom repairing material after concreting work
rimmer in pile foundation
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
