Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / alok
kwh is the measure of kw consumed per hour (i.e. ENEGRY)
and MW is measure of simple power.....
both are different physical quantities , so we can not
relate them....
it is like how may km in 26 m/sec ??????
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain about Leakage Test.
What is pole of the system?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
why ct ,cvt should be stored in a vertical position?
what is cathodic protaction?
what is basic difference betmeen normal & flame proof motor??
What does a Bode plot tell you?
why HT armoured cable does not glanding
Why HT 11 KV Slipring Motors are connected in star ?
what are the ''pitting rings''and how cn they be controlled in a series generator
how freewheeling diode improves the powerfactor
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
