Interested to Buy Any Domain ? << Click Here >> for more details...
a room heater is connected in serise with a 100w bulb.if the
100w bulb is replaced by a 40w bulb then the output of the
heater is increase/decrease/remain same?
- 9 Answers
- 27223 Views
- College School Exams Tests, I also Faced
- E-Mail Answers
Answer Posted / syed ali raza naqvi
output same because in series current is same.in every
point and voltages different.
| Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
what types of electrical & mechanical test conducted in switchyard?
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
What are the different types of dams?
how to deside the capacity of chock for drive?
Why the power factor improvement is so important in industrial loads
What is VCB? where it is installed at SP. What is SP?
What is non-minimum phase transfer function?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
pls someone send me sample question papers along with the key.thanks in advance
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
what is protection class current transformer.
