a room heater is connected in serise with a 100w bulb.if the
100w bulb is replaced by a 40w bulb then the output of the
heater is increase/decrease/remain same?
Answer Posted / yogesh kumar
remains same
| Is This Answer Correct ? | 9 Yes | 14 No |
Post New Answer View All Answers
How 3 phase invertor works?
what is the difference between Power and Distribution transformers ?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
Define active filter?
how many types of motor can be used in washing machine
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
previous year paper of ntpc bhel for degree in electrical enng
What is the source of dependent source ?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
What is the meaning of floating point earthing in battery backed systems ?
what is ground fault in ACB?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.