Interested to Buy Any Domain ? << Click Here >> for more details...
What is micromotion transmitter? What is the porpose of
using this transmitter?
- 2 Answers
- 7199 Views
- Samsung, I also Faced
- E-Mail Answers
Answer Posted / jazz
Micromotion is the brand of the coriolis mass flow meter of Rosemount Inc.. These types of flowmeters give true mass flow rather than volumetric flow with very high accuracy, sometimes 99.9% accuracy in mass flow measurement, mass flow is not influenced by changes in pressure or temperature, hence these flowmeters are very good choice whenever you need to measure mass flow of liquids or gases. This flowmeters uses two vibrating tubes or single vibrating tubes depending on vendor/technology.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Explain working principle of lvdt?
Q- What are the application in which PNP transistor is preferred over NPN ?
What is the working principle of the magnetic meter?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is difference between fork type and capacitance type level switch. where it is using
if in a level tx height is given, how u calculate the ranges of the tx?
In turbine what does term CDP, NH, HSSOC means.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
How will you calibrate PID controller? explain with example.
what is 24vdc live and dry supply
What is offset in a control system.
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
