Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / natha
mineral oil.for more details on testing and other standards please visit this link
http://www.bis.org.in/sf/etd/ETD03(6251).pdf
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
What are the advantages of vscf wind electrical system?
How to calculate VCB rating for 33KV ,25 MW Power line?
what is a reactive power? what is the relation with power factor?
why i can not use thimble on capacitor duty contactor
Explain thin film resistors and wire-wound resistors
when elecromagnatic waves are propogated in a wave guide?
what are the analog quality input for protection function?what are minimum reqiments?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
why magnetising curve not start with zero voltage?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
