Interested to Buy Any Domain ? << Click Here >> for more details...
srry for inconvnce ..here is complete qs...ignore the previous 1
3 router configured with RIP & Ripv2
rotuer 1- connected with router 2 having sr ip 10.0.1.2
routing : ripv2
E0:192.168.1.10
router 2: connected with router 1 and router 3 having sr 0
ip 10.0.1.3 & sr 1 ip 11.0.1.2
routing :rip & ripv2
E0=192.168.10.2
router 3: connected with router 2 having sr ip 11.0.1.3
routing: rip
E0=172.16.10.2
is there communication possible?
- 5 Answers
- 8301 Views
- Cisco, I also Faced
- E-Mail Answers
Answer Posted / ranji2011
Hi,
You should configure the RIP version 2 on both the sides. It
will communicate.
Ranji.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between static and dynamic routing?
When we do default route?
Can you explain in a generic manner the packet of IPSec?
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
What is fcs?
What is the virtual path?
1350 Value in which type of access-list?
Explain the benefits of vlan?
When does network congestion occur?
Explain the types of nat?
In stead of 0.0.0.0 wild card mask what you can write after ip?
Explain the difference between half-duplex and full-duplex?
What is the subnetmask of / 27 in network based and host based?
Which protocol works only on cisco routers?
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
