Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / meeran
The bus coupler use only connect the two bus bar. Bus bar
length will go more then 3 meter or our required length that
area we are using bus coupler.
| Is This Answer Correct ? | 5 Yes | 17 No |
Post New Answer View All Answers
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
i want wipro vlsi placement pattern please send me
What types of high speed CMOS circuits have you designed?
what is rocking arrangement in arc heating
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
what is reactive power?, why its measured in VA ? is it transient behavior of system?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
what is the cause of voltage dipp or swell in the transmission lines?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
