Interested to Buy Any Domain ? << Click Here >> for more details...
What means zero and span in transmitter callibration.
- 8 Answers
- 62437 Views
- Bajaj, Wartsila, I also Faced
- E-Mail Answers
Answer Posted / ashish namdev, bina refinery [
The transmitter working with a range which feed by user
according process parameters.
The transmitter is a combination of primary sensor,
transducer, converters, signal conditioners etc. when
transmitter read any value that value sense by primary
sensor then convert into electronic form after then
filtering, sampling, conversion many process will to be done
for get output value. when these all process do then the
combination of all internal & external
hardware/software/electronics parts don't get
synchronization for any particular value at a time.
for remove these problems we set zero & span. that new
value create a new scale to read unknown value in
transmitter EROM memory portion. that new value will work as
URV & LRV for the transmitter.
| Is This Answer Correct ? | 16 Yes | 7 No |
Post New Answer View All Answers
What is the use of GMV in turbine?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
components of control circuit belongs to control valve
this site is owned by an nonsense
whatis range of marcury filled tempereture gague
Galvanizing.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Explain why use mmwc unit?
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
how works encoder in plc
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
why we r opening HOT BYPASS valve during startup of a compressor?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
