Interested to Buy Any Domain ? << Click Here >> for more details...
How to get Cv of control valve having following parameter
,i.e inlet pressure 4.5kg/cm2
outlet pressure 1 kg/cm2
specific gravity 0.808
- 3 Answers
- 6722 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhiic2008
please provide the calculation form for this
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
Please tell me details about Sox,Nox,SWAS analyser????
Explain the use of hair spring in the pressure gauge.
why using negative supply for bentley nevada vibration system ?
Which products are available in the Mass Systemswitch and System Manager AC range?
How to measure the dust in chimney(spm)?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
How to Calibrate Level Switch in field
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
What is the difference bitween control net scaner and device net scaner
what is the difference between -24 : +24 & 0:24 and where it use?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
give some question relative instrument fitter?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
