Interested to Buy Any Domain ? << Click Here >> for more details...
In separator VFD frequently trip with OVER VOLTAGE Fault
What is the reason?
- 4 Answers
- 8150 Views
- I also Faced
- E-Mail Answers
Answer Posted / u.prabhagaran
motor or high capacity.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
send me last 5 years questions asked in rrb chennai, for section engineer
Programmable Logic control.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
how to relay switch sense the fault?
what is the difference between profibus and controlnet networking.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Flammable gas detector in field
Explain about the leakage class of the control valves
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Explain the burnout feature.
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
