Interested to Buy Any Domain ? << Click Here >> for more details...
IT IS DESIRABLE THAT THE INCOMING MACHINE SHOULD BE A LITTLE
FAST AT THE TIME OF SYNCHRONIZING.EXPLAIN?
- 1 Answers
- 3517 Views
- I also Faced
- E-Mail Answers
Answer Posted / sharath kumar
because at time of synchronization the speed of the incoming
machine comes down since the incoming machine tries to share
the load
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Why is the air gap between the pole pieces and the armature kept very small?
What are IR values and what it should be for coil and for insulator
What is time invariant system?
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
what is feed back and what are feed back amplifiers?
what is maxemo work permit procedure
What is the count of hvdc transmission lines in india?
are there rmu for 3 transformer?
how can we find thae value of capacitor for single phase motor. what is difference between starting capacitor and running capacitor.
how does ELR works? explain
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
