Answer Posted / raghavendra
If a rated dc voltage is applied to the primary, flux produced
in the transformer will not vary but remain constant in
magnitude and therefore emf is not induced in the secondary.
since the resistance of primary winding is quite low, a heavy
current will flow through primary winding which may result in
the burning of the primary winding
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how many single tension hardware are required on a double circuit transmission tower?
Why 11kv to be generated in generation station
Why single phase induction motors are not self starting ?
Why AC & DC capacitor are use in UPS ??????????????????
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
direction of tarbine& genrator
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
why zero sequence impedance measurement is not applicable for single phase GT
