Answer Posted / bala
contactor:
A contactor is an electrically controlled switch used for switching a power circuit, similar to a relay except with higher current ratings.
circuit breaker:
A circuit breaker is an automatically operated electrical switch designed to protect an
electrical circuit from damage caused by overload or short circuit. Its basic function
is to detect a fault condition and, by interrupting continuity, to immediately discontinue
electrical flow......
so finally,contactor used for switching.......and circuit breaker is used for to protect a circuit.so that one is interrupt device.....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
Draw a block diagramof Three UPS systems connected in Parallel mode?
What are the different types of LT Cables?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
i need previous entrence exam papers of nhpc.
How to back charge the Gas turbine generator
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
What is accuracy of a measurement?
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
Where servomechanism is used?
