Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / atul kulkarni
Governor is used to vary the steam flow to Turbine blades in order to increase or decrease the Turbine rpm to achieve the electrical load requirement.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
what is effect of specific gravity in differential level transmitter , explain formula related with this .
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
Name different types of bourdon tubes.
Difference between ultra sonic flow meter
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Turbidity analyzer working principle ?
describe flow nozzel principle?
what are the diff. in servo and regulatory control?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
TECHNICAL/ARTITUDE
how do u calibrate the vacuum transmitter if it shows more reading
