Interested to Buy Any Domain ? << Click Here >> for more details...
Why under frequency protection is needed for a generetor?
- 2 Answers
- 20094 Views
- I also Faced
- E-Mail Answers
Answer Posted / azkal
gen under freq is needed to protect the generator and the
load, -for generator because under overloading condition
the generator will slow down to try to accomodate the extra
load, this will result in overheating of stator windings,
while also under this condition (under freq) some equipment
can be damage or stall because of under freq. A load
shedding scheme using dedicated freq sensing relays will
trip (disconnect) a set of load from the grid to recover
from under freq and stabilize the system avoiding damage to
generator and connected equipments.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
What is the law of thermodynamics?
What is screw,centrifugal and rotary type compressors,how it works and what is principle .
en 19 & en24 which one is good for pipe mill shaft
WHAT MADE YOU BECOME AN ELECTO-MECHANICAL ENGINEER?WHAT IS YOUR JOB DESCRIPTION?WHERE DO YOU WORK?WHAT ARE YOUR JOB RESPONSIBILITIES?WHAT IS YOUR WORK ENVIRONMENT LIKE?WHAT IS YOUR EDUCATIONAL BACKGROUND?WHAT COURSES DID YOU NEED OR ARE VALUABLE FOR YOUR POSITION?WHAT ARE THE ADVANTAGES OF YOUR JOB?WHAT ARE THE DISADVANTAGES?WHAT MADE YOU GO INT THE FIELD?HOW MUCH SCHOOLING DID YOU NEED?WHAT DID YOU NEED TO STUDY?
Explain how do motion detectors work?
How to start water tube steam boiler
Which pipes are used for steam lines?
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........
What is the difference between stalling and surging in rotary compressions ?
Can I use motor oil in a hydraulic system?
What is meant by direct heat exchanger [or] open heat exchanger?
How do you control cylinder liner wear?
what is Direct control valve ? explain its practical applications?
give an example whenu should initiative and took the lead.
What is the difference between conversion and enrichment ?
