Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / muthuelectric
it is a protective device used to protect the device or
system during fault conditions
| Is This Answer Correct ? | 7 Yes | 7 No |
Post New Answer View All Answers
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
a governer in an Ic engine controls the
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
what is the ATS .And how it works.
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
What is star-delta transformer?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
Phase control and integral control are used for?
why in the three pin plug all 3 pins are cutted ?
How do apply electrical 'c'license......pls advice
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
What is difference between isolator and circuit breaker?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
33kv substation lay out details & line to line & line to earth measurements
how cables go in and come out for distribution from the feeder pillar box?
