Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
Horn gap fuse is fixed between two rods bent to form the
shape of a horn facing upwards.It is also called as HG fuse
in short.It is used on 11 KV side of DTC (dist tr center)for
protection against overload for each phase.
| Is This Answer Correct ? | 25 Yes | 8 No |
Post New Answer View All Answers
why we use copper earthing for neutral while for body GI.
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
What is the source of dependent source ?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
What is dynamo function in DG sets and draw block diagram?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
What is steady state response?
trasnfarmaer core make
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
State the frequency for rc phase shift oscillator?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
how to calculate the Neutral transformer impedance?
