Interested to Buy Any Domain ? << Click Here >> for more details...
EXPLAIN PROPOTIONAL INTEGRAL DERIVATIVE CONTROL ACTION?
- 1 Answers
- 5467 Views
- I also Faced
- E-Mail Answers
Answer Posted / ecxlsync
Proportional is to respond the magnitude or error of the
process.
Integral is to respond the number of error occured at a
given time (integral time).
Derivative is to respond the rate of change of the error at
a with respect to time.
PID is a Control algorithm to perform a control action on
the final element usually a control valve to correct the
error of the process value and lead-lag effects.
proportional term will determine the amount of
opening/closing the valve with respect to the error signal.
Integral will eliminates the offset and tries to set back
the process value to the setpoint.
Derivative is to reponds quicky as the error is about to
occur.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
What is motion balance principle?
what is the difference between scaler and vector drive
Explain the working principle of lvdt?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
What is the working principle of the magnetic meter?
Make Heater Process Logic.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How to work temperature gauge?
State bernoulli’s application.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
What is the use of GMV in turbine?
