Answer Posted / praveen kumar gupta
Electronic means micro control of movement of electrons and
holes where as electrcal means macro control of high
speeded elecrons in a conductor. In electronics one can
control the speed of electron as per requirement but in
electrical one can only switch the motion of the electron.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is the purpose of silicon dropper used in battery charger?
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
what is the chiller and working principal
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
why asa method ZPF method is more accurate than ASA method?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
If any cable burnt how can we identify it burnt by high current of high voltage?
what is the relationship between phase & neutral
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
explain single phase series motor
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
Can clean earth cable be considered as low current cable
