What is auto transformer?
Answer Posted / divyaprabha
An autotransformer is a tapped winding transformer that
changes the voltage available locally to the voltage
required by a particular load. Thus, a load may operate
anywhere around the world, as long as a transformer is
available to convert the local voltage to the voltage it
requires.
Is This Answer Correct ? | 26 Yes | 37 No |
Post New Answer View All Answers
why -48 volts dc used in telecommucation
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
Safety of on line ups
What is Tachometer used to measure?
While testing a ZCT what parameters have to check or measure?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
Who many reason of ignition fail ?
how to measure the current by compact digital equipment with dislay which fit inside any equipment