Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 35908 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / dayanidhi nayak
for star- Iph=IL
delta= Iph = IL/1.733
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
with help of neat sketch explain principle of TIG welding process
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
There is any especial requirement for motor to drive through with VFD?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
How equivalent impedance is calculated in thevenin theorem?
how you configure motorvision relay (L&T make)from DCS
distribution is maximum done by a)radial b)network c) parallel d)b & c
What are the essential characteristics of signal flow graphs?
what is lrs tank water resistance.
State the methods of improving power factor?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
How shall i select the value of capacitor or inductor in a system?
