Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vnod.g
Governor is using control the power output when generator
is synchoronised with grid by adjusting the fuel ie. the
load fluctuation will not increase or decrease the load
from the generator.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
draw the block diagram of a level transmitter ?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
what is span value and zero ? and how set ?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
what is the procedure of belt scale calibration?
What is stripper & spilitter ? Diffrence in this.?
what is intrinscily safe system and where we use?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
What is Span Error
