Answer Posted / thenmozhi r
its refered as the voltage and current is inphase and have
same magnitude.
| Is This Answer Correct ? | 4 Yes | 13 No |
Post New Answer View All Answers
How to setting the volume of RTCC panel AVR (11kv) controller
How can we calculate cable size in Low voltage & high voltage
what is the sludge current
When are the directional relays used?
What is reverse power relay?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
what is the difference between droop mode and ischnorous mode in thermal powerplant?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what is relay what is protection & contact multiplying relays where it is used function in brief
what the principle of sincroscope?how it works?when it needed?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
does any one know where we can purchase insulation oil for high voltage oil filled cables
what is the condition for YnD11
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
