Interested to Buy Any Domain ? << Click Here >> for more details...
What is the maxi. percentage of steel in compression
memeber of C/s area & what is minimum dia for compression
member as per IS 456:2000?
- 1 Answers
- 4700 Views
- I also Faced
- E-Mail Answers
Answer Posted / tusharpatel18
AS per IS 456:2000,Maxi. percentage is 6% of C/S area of
member.However it is limited to 4% in considering spacing
between bars & pouring of concrete.The minimum bar dia for
compression member is 12mm.
| Is This Answer Correct ? | 26 Yes | 0 No |
Post New Answer View All Answers
can any one tell me in detail footing estimation .. i am new here in dubai so facing lots of problem...
What is meant by solid geometry?
what is the formula for Mass of cement grout (Dg)=???
what is Brest Wall?
How will you reduce the concrete flow after mixing the concrete
LET ME KNOW HOW IS CALCULATE RUBBLE WALL .3'00" IN BOTTOM 1' 6" IN TOP HEIGHT 8' 0" AVERAGE. length 200'00". please give correct answer.
though u r a civil engineer, y r u interested in tcs???
For what building Built-on balconies are preferable? What are the advantages?
what is project?
What is the withdrawal force of steel nails?
How to estabilish reinforcement Steel rolling margin for a building projects ?
how to determine H- zone in a column? where it will occur?
What is the difference between EPC,DBOOT and BOOT.
In tower foundation, on the time of 3 mtr pit RCC casting if water and mud is their surface of PCC then what will be do?
what is escalation?how it is done?
