Answer Posted / gurunath khavanekar
1) insert your hand in cement it shuold give cool feeling
not warm(moisture conten).
2)it should not content any lumps or dust
3)it should be green color
4)take pintch of cement rubbed between fingers it should
give smooth finish(feeling).
5)take handfull of cement and throw it into bucket full of
water it should float on the surface of water for some time.
| Is This Answer Correct ? | 42 Yes | 1 No |
Post New Answer View All Answers
how to identify np3 pipe and np4 pipe
what is pqc
where can i get the previous question papers for rrb section enginerr (civil)
Floor to floor high of domestic building is 3m design a quarter turn staircase starting assume taken give a suitable diagram of it?
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
Explain how you can turn off the display for dimension in CAD?
For what purpose bedding is used under storm water drains?
if a pipe those configuration (ASTM c 76 class b 450mm dia 2500mm length) fixing for water course those lining of water is 7000 running meter. my question is that if 8 joints of pipe ls leakage and we have not permission to stop the water so which treatment we apply on joint in that in condition.
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
what is high type road and low type roads
What are segregation and bleeding?
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
what is meant by residual strain?
How much cement and sand required for 9"brick wall per square metre
the distrubution system in water supplies is designed on the basis of avg daily demand peak hourly demand coincident of draft greater of B & C