Interested to Buy Any Domain ? << Click Here >> for more details...
what is the purpose of checking IR and Megger values in
motor windings?
- 5 Answers
- 10169 Views
- I also Faced
- E-Mail Answers
Answer Posted / udaya17
is it to check open or closing circuit of the motor windings
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
pre arcing time of ehv breaker
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What is the numerical quantity of sqcm?
Why Neutral Isolation is required?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
excitation limit of an excitor
In CTs tan delta point should be earthed , what is the reason behind it?
Transmission through a short line depends on
what is self capacitance of inductor
What is the feedback in the control system?
Explain The Application Of Storage Batteries?
should %impedance be high or low in a power transformer? if so why?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
