Interested to Buy Any Domain ? << Click Here >> for more details...
what is the relation between frequency and inductive
reactance in a d.c supply?
- 2 Answers
- 7018 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / lashari
The concept of reactance (inductive or capacitive) is only for the AC current or voltage not for the DC and the frequency of DC and zero..... and reactance is only where the frequency in present.
www.bestarticlez.com
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calculate the heat load for a electrical room
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
what is the meaning of osr in transformer.
What is accuracy of a measurement?
I want the details about BHEL company examination.Can anyone able to help me please.
which type of stability limit is higher,steady state or transient? why?
what is the relationship between current&voltage in practical purpose ?
What is the difference between rated and per unit in transformer?
is oil viscosity affect on motor current?
why star point of HT motor not earthed?
what is ic 01,ic 06 ?is it types of cooling?
how current is reverse from its normal direction during the fault?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
What is current & voltage ? Voltage perform at any load without current or not?
