Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satish
DIFFERENTIEAL BUSBAR
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
What are Contactors? How they works and what its highest rating?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
static chagre
What are the advantages of autotransformer?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
State thevenintheorem?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
whate is the meaning of balance/unbalance,in stabilizers type
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
why in the three pin plug all 3 pins are cutted ?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
Write a note on Treatment for electric shock.
