Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between star and delta connection ?
when we use each one ?what is the best ?
- 14 Answers
- 55248 Views
- Amara Raja, Daikin, I also Faced
- E-Mail Answers
Answer Posted / s k singh
For transmission, delta connection is suitable while for
distribution system, star connection is sutable because
nuetral is available in star connection.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
How can I known multiplying factor .without multiplying table
What is the Resposiblity of Electrical Utility Engineer
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
what is acceptance test in electrical engineering.
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
Why Neutral Isolation is required?
What are the protections for safe running of electric generator?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
Explain Creepage Distance of Insulator
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
