Interested to Buy Any Domain ? << Click Here >> for more details...
What is OLTC in a transformer, specify its fuction.
- 35 Answers
- 143342 Views
- Bhel, Isgec, L&T, I also Faced
- E-Mail Answers
Answer Posted / sanjivani mhaske
OLTC is On load Tap Changer to maintain constant voltage at
secondary side according to change in load. Tappings are
provided on HV winding as this winding is outer on the core.
So less insulation will be required. By changing taps on HV
side, we can monitor voltage at secondary side. Basically,
this tapping is provided on HV side because there is high
fluctuation of voltage on HV side (i.e. from supply
company). Tap changing process is done by RTCC (i.e. Remote
Tap Changer Controller). This is installed in HT panel of
transformer. RTCC sends signal to LCP (local control panel)
which is in turn motor rotates it rotor as per signal
received from RTCC. It is generally used for higher capacity
of transformer.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
What is George phenomena to start the synchronus machine?
What are the roles and responsibilities of electrical engineer in cement plant
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
can anyone provide me a amf panel control wiring using ec-2 relay?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
Difference between ac parallel circuit and ac series circuit?
how to determine Sq.mm size of finolex power cables.
what is negative and zero impedance in 3 phase induction motor ??
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
what is the meaning of 0.5ohm Resistance
Why the arms of delta in a delta-wye power transmission system are kept constant??
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
