sir,
how to select the cable size, what is the parameters use
ang what is the formulas use for this cable size
calculations. please tell me.
- 4 Answers
- 13207 Views
- ISRO, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / raul
cable size depends upon THE MOST ECONOMICAL CONDUCTOR SIZE
concept in which the size depends upon the max. dielectric
stress on the conductor..........i.e. g(max.)= 2V/dlogD/d,
where V=voltage, x= distance from the conductor centre,
D=sheath diameter, d=conductor diameter........by
differentiating above relation n equating to zero......we
get logD/d=1 i.e. d=D/2.718...........
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How to select HT/MV cable size ?
Define cuttoff frequency?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
what is the function of statics switch in ups and tell me parts
How you give clearance to a spare feeder.
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
why tertiary winding is used in transformer with diagram?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
what is the ATS .And how it works.
What is the formula to calculate the size of Aluminium and copper cable?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
How to calculate the fuse rating depend upon the DC circuit?
Could you measure voltage in series?
how to select proper cable for ct wiring so that drop within the limit.
