Interested to Buy Any Domain ? << Click Here >> for more details...
why the supply power frequency is 50hz in india? where as it
is 60hz in US?
- 4 Answers
- 8747 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunnyrr
50hz was set by britishers when they are in india after that
india run their machine on 50hz so it is basicallya set
frquency but we can also be work on 60hz.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
what are the factors to be considered while design the breaker either HT or LT??
how to carried out tan delta test in 11 KV alternator ?
if i am in front of transmission line how to know that current direction without any equipment
What is the percentage loss for aluminium wire for HT line more than 11KVa
What is Bolted fault?
what happens if dc supply is given and the remedies for it.
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
How you will determine the volume of oil in a particular Distribution transformer.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
