why we generate transmit and distribute electrical supply
in multiple of 11
Answer Posted / kmsnow@yahoo.in
the ans is form factor (FF). The form factor is 1.11 for
sine wave . while we are calculating the voltage produced by
the generator we are using form factor for the same. so all
standard voltage ratings in world are of multiples o 1.11
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
How to calculate cable size by using load.?? Any formula...
what is servo motor and how to work it.
At full load wat is the motor p.f And at no load will is the motor p.f?
what is the isolation transformer. what is the isolator?
how to build a network which step down 415v to 1v rms
why they were using TRIAC instead relay in some controllers and what is the advantages.
how calculate the electrical load for industry and office
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
How to maintain ac plant?
What is the difference between the transmission line and distribution line?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act