Answer Posted / tim
typically this can be done using a high potential device
that applies a high voltage signal to open circuited
conductors. The meter on the device measure the micro-amps
of leakage through the insulation of the cables.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why servomotor motor? where i apply for best output?
please send previous exams question papers
how to failure indution motor insulation & how to improve heat in motor insulation
How to calculate the heat load for a electrical room
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
defination of lines
what is the difference between neutral and earth
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
what is the formula for computing cable tray size & capacity
how much GROUND & NEUTRAL VOLT maintain in data center.
whate is the meaning of balance/unbalance,in stabilizers type
What is the difference between Droop vs Isoch Control?
