what will happen when ac is applied
resistor,inductor,capcitor?
- 1 Answers
- 3733 Views
- I also Faced
- E-Mail Answers
Answer Posted / tim
a resistor will heat up due to resisting current flow, the
inductor will produce a magnetic field, the capacitor will
store electrical charge
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
i have a 1500kVA transformer what is the kWH meter i need to use?
what is the relation between size of the anteena and wavelenghth of radiated wave
what does a k rating in a transformer means?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
What is self exciting?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
can i use 2000/5A Clamp meter to measure HT cable
Define norton equivalent circuit?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
which metal is use in shunt
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
What is evaporator & condencer & compressor
What is Auto Mains Failure Panel & Auto Synchronizing Panel
