Interested to Buy Any Domain ? << Click Here >> for more details...
what is the problem with single phase AC motors and how is
it overcome?
- 2 Answers
- 4961 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahidniazi
when we use only single winding then no rotating flux so in
single phase motor is not actually single phase but split
phase mean 2 windings so that will produce rotating field
and rotor will move.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
why HT armoured cable does not glanding
how to calculate the earth mat design in 132 kv substation yard ????
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
block diagram of 2 ups system connected in parallel mode?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
how to test reverse power trip?
How to calculate the sag of OPGW during stringing???
how we calculate the dick for a pole?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
What about electrical Units. discrive in detail
What are hrc fuses and where it is used?
