In a transformer, the hysteresis and eddy current losses
depend upon
1.load current
2.maximum flux density in core
3.type of lamination
4.supply frequency
The correct statements are
(a) 1 and 3 (b) 2 and 3
(c) 1 and 4 (d) 2 and 4
- 9 Answers
- 11448 Views
- I also Faced
- E-Mail Answers
Answer Posted / bunny
3 & 4 as loss is directly proportional to square of f nd
thickness of lamination
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Give the topology of current amplifier with current shunt feedback?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
How to know of any cable size if there are not written on cabl?
why we use circuit breakers for switching instead of normal switching device?
why booster transformer is used in sumpners test conducted on transformer????
Transmission through a short line depends on
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what will happen if synchronous machine rotor fed from single phase ac supply
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
1.What will be stored in online ups EPROM IC?
what is mean by dry frequency
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
