Interested to Buy Any Domain ? << Click Here >> for more details...
how to test vector goup of Dy11 transformer
- 1 Answers
- 15753 Views
- APPSC, I also Faced
- E-Mail Answers
Answer Posted / prasad@clp
HV side Delta,LV side Star
1) Connect HVside with 3 phase supply,
2) Short with a cable HV R phase & LV r-phase,
3) LV left open circuited
4) Now Switch on the 3-phase supply
5) Now Measure the following Voltage's
VRY,VYB,VRB
VRN,VYN,VBN
Vry,Vyb,Vrb
VRr,VRy,VRb
VYr,VYy,VYb
VBr,VBy,VBb
6)CHECK the following condition(These are derived from
Phasor diagram)
i) VBb<VBy
ii)VYb=VYy
iii)VRY=VRn+VYn
iv)VYb<VYy
If these all conditions are satisfied then U'r transformer
is OK
ALL THE BEST------Prasad
| Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
Differentiate between induced emf and self inductance?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Which standard we are following earthing resistance test
how to read idmt curva
testing of Vector Group – YNaoD II
On what basis the the size of Lightning arrester for buildings are selected ?
what is the formula for computing cable tray size & capacity
Details about Flux Compensated magnetic Amplifer starter for motors
Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?
what is the difference between megger and earth resister ??
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
Can a generator runs after getting 1st stator earth fault.
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
