Interested to Buy Any Domain ? << Click Here >> for more details...
Normally the
starter used to
reduce the
starting
current.but the
dol starter do not
it,so why we use
it?
- 4 Answers
- 9451 Views
- I also Faced
- E-Mail Answers
Answer Posted / ali
i have seen many dol motors r just running on mcb without
creating any porblem for last 4-5 years dol startor are
soft stator which is manually operated suppose in an
industry to cut metals having hacksaw machine(dol motor)
which is merely operating on mcb suppose machine in ON
suddenly there is a breakdown in electrical supply & will
resume after 2 hour & operator will assume 2 hour is
sufficient time to clean the machine & these is a good time
lets take full advatage of it & he started to cleaning the
machine & forget to OFF the mcb he is cleaning & removing
burs from blade teeth suddenly suply resume 1 hour before
than the mentioned time what will happen??????????
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
why use phase displacement in transformer.and effect of phase displacement on transformer
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
what is interfacing in computer studies?
what is the use of permanent magnet generator in exciter
What is the function of retrip in busbar?
sir vizag steel ka junior trainee ka paper kitne number ka ayega
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
1.what is the reason for transformer and lightning arrester blast in 33kv system
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Explain the advantages and disadvantages of thermal power plant?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
How can calculate the rating of a alternator for a given specific load with formula
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
